-
When i format my cards on win 8 pc it just uses quick format..takes 15 secs.. The card then shows itself as empty.
As for the bb disconnections then yes the pi just loses connection from router and in turn your controller. Only thing to do is switch off for say 20 secs. That allows all the internal charges to decay. Then power up. Usually works first time although it sometimes still misses... Not often though. As said earlier you may only be seeing what windows can read so best to format at fat32. If your pc doesnt do it then there are utilities that can. A clean instal on fat32 card should work first time. Also on restarting you will need to check that the pi has not been moved. IE from /7 to /6 local addtress or similar..putting your router address into a browser a!d refreshing should show whats connected to it... Ive never managed to get mine to work wirelessly so its easy to find for me as moode is the only wired connection
-
Hi Steve,
Size showing of SD card is correct. It's been created as a boot disc so will only show up as 75mb.
When updating any of the settings remember to 'refresh/reboot' MoOde so the settings are saved.
Rebooting can take a good few minutes to come back up on your desktop so don't be too hasty.
Mike
-
Deep.. Deep Joy !!
Ok, formatted to fat 32.
Re-imaged card.
Put card back in Pi - then powered up.
Then configured by starting with system first, then MPD ( hardware for vol,set at 86)
Then finally source.
Bingo- it's now reloading my nas library.
So relieved.
Also a sense of understanding.
I remember the early days of linns DS system also having an awful lot of issues.
This is no different - it's all developing.
-
-
Hi Steve,
You can set it to 100 as that is now 0db and adjust up or down from there. It used to be 86 last time I looked but it's been changed to 100 now, so you might find an improvement if you go to 100.
Mike.
-
Cheers Mike
That's interesting.
I'll do that then!
-
Now Ive set it to disabled.
Looks like there has been some changes.
Will check it's working shortly.
-
Bugger... Now nothing! In terms of volume anyway..!
The library is building itself nicely again though. Just got to figure out getting some sound out.
-
Wrong is2 driver? Alsa if available too low?
-
Funny thing is (OK, not that funny), that I can't enter a volume fig now in the box, as below.
http://i82.photobucket.com/albums/j2...psnahbqt34.png
