:lol:
Printable View
:lol:
Quote:
Originally Posted by Mike_New
I already have one ;)
Quote:
Originally Posted by Audio Al
That has has not been played in anger.......
:ner:
I am sorry Audio, I don't how to put this but I didn't know you had one.
Oh yes I have one , purchased in a TT from a forum member on AOS along with other upgrades ;)Quote:
Originally Posted by Mike_New
Quote:
Originally Posted by Tarzan
As someone said to me " Patience my dear fellow.. patience ";)
Quote:
Originally Posted by Audio Al
l would be of service and run your MN bearing in for you in for you Al, as indeed l am running in your Croft- that sounds very nice............:):cool:
Delighted with my MN bearing having had both stock and Vantage bearings in the past - decided not to get a MN bearing plate purely because I don't want the platter raised up as I like the look of it in the original position - however, a small but audible improvement is to be had by using KAB support wax - care needed to ensure the MN bearing is fully seated in the bearing well so judicious use of a hair dryer on the wax - only takes about 20 minutes to do but rewarded by tighter bass and timing.
Steve
Sent from my HTC One using Tapatalk
Interesting, Stephen. I've never heard of KAB support wax.
Hi Martin.
www.kabusa.com and go to their Technics page - the support wax was hugely beneficial to the stock bearing so thought I'd try it with the MN. The MN is deeper than the stock and the 3 bolt heads are just above the base of the bearing well so need to really make sure the wax does not cause it to rise up or be uneven - it provides a solid and uniform support for the bearing housing for a couple of quid which does firm up the bottom end
Steve
Sent from my HTC One using Tapatalk