:popcorn:
/Mike
Printable View
:popcorn:
/Mike
It's gonna be :partytime: when you finish. Then you just have to figure what record to play first when you get it back.
The 301 will also be living with a SME 3012. My SME 3012 is also being fettled by J7 at Audio Origami. You'll be pleased to know that there isnt an ounce of silver in this system, its an all copper affair. Unlike the 1210 setup of pure silver cabling etc. I'll be on the look out for some decent speaker cable, and maybe some new valve amps :eyebrows:
:yay: it's coming home tomorrow, doms finished the bits I couldn't do. Pics to follow in next few days :cool:
:popcorn:
Now I'm getting all excited as well :lol:
It's arrived today, will post some pics when I drag it home. :cool:
OK, the SME 3012 has been fully fettled and restored, heres whats been done
strip and clean both knife edge and horizontal bearings
strip and refill arm cue with silicon
replace rear stub rubbers x 2 rebuild and check
clean arm tube and arm pillar area from oxidised marks
rewire arm tube with cardas 33ga ofc coper litz
fit extra cardas gold 5 pin base detachable connector
Quite a lot :stalks:
The 301 is now sitting on my bedroom floor from Northwest analouge, I fitted a power lead today. It works a treat and is silent as death :eek:
I await my koetsu black. I will be making a temporary plinth until I get my stone one made. Then I'll have to make a custom rack (maybe next year!).
ok, here is the first pictures of the 301 and the SME 3012 back from Northwest analouge and audio origami. Not much to look at but I intend mounting them in a temporary plinth by the end of the week. :eyebrows:
Looks to be beautifully restored to mint cond! I'm sure youre kind of eager to hear it now, aren't you? :D
Looking forward to following the tt's path to glory!
Regards /Mike