Free cartridge upgrade...... it works plus Jelco 750 alignment info

Ali, you may want to try this protractor generator from Conrad Hoffman: http://www.conradhoffman.com/chsw.htm

Works under Windows, all you need is your pivot to spindle distance and selection of groove radius, as you have a Jelco the recommendation is to use DIN and probably LofgrenA but I doubt there's a huge amount of difference between that and Stevenson / IEC

VinylEngine thread where I found it: http://www.vinylengine.com/turntable...p?f=19&t=16849

Ah! no external linking, this is the thread title: My new alignment template generator

Cheers Neal, I'll take a look.

I'm now using a Stephenson alignment on my Jelco/Oyaide/Benz micro Ace SM. Baerwald wasn't achievable without a rubber washer, and then only just... I think the inner alignment position was still fractionally out. With Stephenson alignment, the washer wasn't necessary albeit that the cartridge was still as far forward as it can practically be.

It is working well though, and I think it sounds better without the washer when the modulation peaks.

Regards,
Alex

Hi Alex,
have you seen this:http://www.zyx-audio.com/products_ac...s_zyxring.html ?
or this: http://www.miyajima-lab.com/e-others.html#washers ?