The Mike New Technics Bearing

Quote:

---

Originally Posted by Canetoad

Hi Mike,

I posted the details on another post of the e-mail you sent me. I was not trying to be malicious in any way and was hoping to drum up some interest so I could get my bearing sooner. If I have caused any confusion I apologize. :doh:

Let's hope interest will re-ignite and you'll be able to do another run of spindles soon. :)

---

Hi Bernie,
Thank you for your support, It did not even occur to me that you were being difficult or malicious in any way whatsoever. In fact what you did spurred me to write the earlier post which happily has generated some more interest,
Thank you again
Mike new

Quote:

---

Originally Posted by Mains Cables R Us

Please remind me again what the treat costs Marco, and doe the bearing need the MN platter or will the bearing do for starters with the stock platter?

---

Hi Dave,

The treat costs $625.00 including postage,
shall I put you down for three or four!!!
regards Mike New

Quote:

---

Originally Posted by Mike_New

Hi Dave,

The treat costs $625.00 including postage,
shall I put you down for three or four!!!
regards Mike New

---

about £403 at the time of this conversion few minutes ago.


Regards D S D L

Quote:

---

Originally Posted by Mike_New

Hi Dave,

The treat costs $625.00 including postage,
shall I put you down for three or four!!!
regards Mike New

---

When Dave wrote that earlier, I thought he'd made a mistake.... What's a "treat", then? :scratch:

Marco.

Quote:

---

Originally Posted by Marco

When Dave wrote that earlier, I thought he'd made a mistake.... What's a "treat", then? :scratch:

Marco.

---

'treat' as in treatment - still a bit early for you Marco?:lol:

Probably! :eyebrows:

But why not just refer to it as a bearing? I thought it was some new invention Mike had made!! :lol:

Marco.

Hi People,
I now have a WebSite put together for me by Richard Quaite and hosted in the UK. it is:--
MikeNewAudio.com
Hope you find it informative and helpful.

You'd better get Richard to change the text on solid copper arm boards then.....

Quote:

---

Precision machined from solid brass

---

Thanks I missed that
Brass does have some copper though so he was about 80% correct!!!!

Quote:

---

Originally Posted by Mike_New

Thanks I missed that
Brass does have some copper though so he was about 80% correct!!!!

---

Even so, 80% copper is not solid copper, is it ;)
I've also been looking at the bearing installation document - some photos would help.
Just found more typos in the platter description.

Quote:

---

This serves to damp out any latent resonance that may me present in the platter.

---

Quote:

---

The new platter assumes the use of an external power supply as the existing transformer and power board may fowl the bottom of the new platter.

---

Any breed of chicken in particular ? Should be spelt as foul.