Printable View
I need just 2. I know you can buy them online but I only need two and I don't want to be left with loads I'm not going to use just to be thrown in a drawer.
Anyone help me out? Obviously I'll pay for the components and postage.
Thanks.
It's times like this that I miss Maplin's. Only a short bus ride from me!
Thanks for looking.
Regards,
Ray
P.S. Could Mods please move this post if it's not in the right category.
I'll have a look in my spares box. All of my electronic components are stored in my garage, along with a whole load of other stuff which needs sorting out, so it might be some time. What are the resistors for Raymond?
Hi Barry,Quote:
Originally Posted by Barry
I'm in the process of buying a Quad 306 to partner it with my Hafler DH 101 (I think you know the 101) Lol
As you know the 101 delivers 3 volts where the Quad only needs 375mv for full output.
The 27 ohm resistor will increase the Quads input to 1 volt to a far more satisfactory level
Regards,
Ray
Hi Barry, having a senior moment, it's 27ohm I need.
Sorry about that.
P.S. Any chance you could amend the title so it reads 27ohms.
Hi Ray
I have a couple of 27ohm and a couple of 22ohm also if you want ,can post thm today if you want (f.o.c)
Hi Mick,
It's a small World! Thank you so much Mick, that would be brilliant!
I think you've got my address lol.
I think you know what I want them for?
Cheers,
Ray
How do you derive a figure of 27ohm, and where will the resistors be fitted?
Hi Barry, from this:
9.1 Ω (Stock): Gives standard 0.375V sensitivity.18 Ω: Lowers gain, raising sensitivity to 0.775V.27 Ω: Lowers gain further, raising sensitivity to 1.0V.36 Ω: Lowers gain to the ideal level for a 1.25V target sensitivity.
Resistor 13 on the Quad 306.
Thanks to Mick, I've obtained the parts I need.
Thank you too Barry for your help, much appreciated
Checked on the 2 digi meters I have,readings were 26.9 ohms for each