FS: SJS Arcadia 18W PSE 300B power amplifier
For Sale
An original Arcadia 18W PSE 300B amplifier has been in for servicing and repairs.
Originally supplied in 1997 it was enhanced with a large external dual-mono power supply in 2004.
https://dl.dropboxusercontent.com/s/...J-outside1.jpg
Following a number of amendments, and a period of time in storage, it has been thoroughly repaired and serviced. A couple of damaged chokes have been replace, some of the psu capacitors replaced, a new pair of 6072A input and 5687WB driver valves, and a new set of EH Gold Grid 300Bs are now being used instead of the TJ mesh plate 300B/n valves shown.
https://dl.dropboxusercontent.com/s/...z4/BJ-psu1.jpg
The PSU contains a large mains transformer for each channel, plus valve rectifiers, choke input and first psu cap for the input/driver psu. The psu is remotely switched on/off from the main chassis.
https://dl.dropboxusercontent.com/s/...BJ-inside1.jpg
Inside the main chassis there are two mains transformers for the 300B filament supplies, and six more chokes for the various power supplies.
In in all there are three valve rectified, choke input filtered power supplies per channel, making six in total. One for the 300Bs, the second for the input/driver stage, and the third for the negative bias supply.
https://dl.dropboxusercontent.com/s/...BJ-inside2.jpg
The components inside are typical of the period, including Elna Cerafine HT caps for the 300B ht, a lot of Black Gates, Hovland coupling caps, Mills and Rhopoint wirewound and even a couple of tantalum film resistors.
The servicing should see it good for many years to come.
Looking for £5,750 including a 6 months parts and labour warranty.
The classic 6072A - 5687 input & driver works very well with PSE 300Bs, but results in a high input sensitivity. If the amp is to be used with an active preamp, such as an SJS Arcadia 1, 2 or 7, and/or high sensitivity loudspeakers, it may be worthwhile to change to the lower sensitivity choke loaded driver stage used in some of the later versions of the amp.
Please get in contact with any questions
