A hello and a power question?

Hello all, this is my first post.

I have what I consider to be a slightly unconventional mid-range setup, so always looking for advice. I'll upload more info shortly on system specs, but here is a short rundown on my system. It's somewhat (in my opinion) unconventional, and I would describe it as being split into three discrete parts:

Part 1 - Home Office

PC > Arcam stock USB Cable > Arcam irDAC > QED Qunex 75 Reference (Digital) & Chord Crimson + (Analogue) > Canton DM50 Soundbase > Oehlbach NF1 Y Sub 150 > Mordaunt Short Alumni 9 Subwoofer

Part 2 - AV system

PC > Arcam stock USB Cable > Arcam irDAC > Fisual Havana XL > Onkyo TX-SR607 > QED XT400 > Monitor Audio Silver RX
My TV also feeds into this loop.

Part 3 - Turntable Setup

Technics 1210 > Stock Technics 1210 RCA > Nakamichi CA5E-II Pre Amp > Van Damme Pro Grade Classic XKE > Nakamichi PA5-II Power Amp > Gale XL105 (To be upgraded!) > Monitor Audio Soundframe


The question I would like to pose right now is regarding IEC connections.

I have a Nakamichi PA5-II Power Amp and Nakamichi CA5E-II Pre Amp both with captive mains cables, and a Furman Elite 10Ei Power conditioner. In order to connect the Nakamichis to the power conditioner, I plan to remove the captive cables and replace with an IEC outlet. I will also need to make up the connecting cables, as I will require a female IEC connector to attach to the Nakamichis and a male IEC connector to connect to the Furman. Now whilst female IEC connectors are a plentiful at all price ranges, it would appear male IEC connectors are relatively rare.

I am looking for a decent cable and connectors in order to exploit the best from my system (this is only a small part of the system). I plan to use something like a Furutech cable off the reel and Furutech or similar female IEC connectors (I have no problems making these up), the real question I was hoping someone may know the answer to is of a high quality male IEC connector? It seems pointless spending (for example) £60 on the cable, £150 on the female IEC connector only to have to use a £5 male IEC connector.

Any help would be much appreciated. Thanks!

Hi Khushru. Welcome to AOS.

I'd suggest starting a thread about the IEC connections in the Blank Canvas section, where you can outline your ideas and get some advice.

Tell us what music you listen to and if you have any other plans for your Hi-Fi.


Enjoy the forum,
Geoff.

Hi Khushru - could you not leave the captive power cords as they are and just change the plug for a connetor?

As Geoff says, start a thread maybe in the DIY section. Lots of people here make up their own cables and power cords so I'm sure you will get good advise and recommendations.

Welcome to AoS.

As above. Best connector is no connector..