Berni217
Senior Member

Now sold thank you

Now sold thank you

Not going to disagree Dave

Haider and Remio are concentrating on smaller hand held devices these days, the last time we spoken them they haver no plans to fabricate any of the...

Also as well as wave form ringing and reflections note the difference in amplitude and positive and negative waveform widths. :)

Thinking about at the above posts I should have constructed a finial post to condense this information into bullet points. Ideal conditions:-...

For the incoming data stream not to trigger either the wave form would have to be very badly distorted on the leading edge or the overshoot would...

Last up 75ohm cable, 75 ohm feed into a 50 Ohm receiver, the lastly adapter added in to the chain for comparison. As you can see the degradation...

Now a genuine 75 ohm audio clock cable using the 50 feed into a 50 ohm receiver, as you can see plus the top edge definition again is greatly...

Next set of images show a 50 ohm cable being fed a true 75 ohm signal to a 50 ohm receiver note the reduced PK<>PK voltage and difference in the top...

As promised some results from using impedance mis matched cables and adapters. I used the lab's Mutec Ref10 SE-120 master clock as the signal...

Sorry for the amount of posts here but its an important question and one I feel needs some in-depth answers. These posts are part of a reply I...