Hi Ali I didn't get around to modifying the DAC this weekend but modified it this afternoon. It works. I need a few hours for the DAC to burn in. Thanks for your help Regards Reg Parker
Hi Reg, The output on the board comes from right next to where the ribbon cables cross from one board to the other.If you look between the ribbon cables you will see a point on the board with a bit of solder right next to the inside edges of where the ribbon cables are soldered onto the board.Depending on which version you have,there may be two points right next to each other at each inside edge of the ribbon cable-you can solder to either of these.If you check oout the passive mod thread,there is a picture posted by Stan which better shows where to connect the wire,except in his picture he has just soldered the leg of the cap straight to the board.I used wire in order to fit the caps at the side of the pcb as I used film caps which are much larger and that was the only place to put them and still get the lid on! Hope this helps.If you need any help just let me know.