Tab Content
  • JohnG's Avatar
    20-05-2019, 19:37
    JohnG replied to a thread Sony TTS-8000 Turntable in Analogue Art
    Just to throw another version of Plinth Material into the mix. When I finally get around to it, I intend on producing one in 'Phonotherm' for the...
    284 replies | 16309 view(s)
  • JohnG's Avatar
    19-05-2019, 16:15
    JohnG replied to a thread isolation blocks in Strokes of Genius
    I forgot to include in my earlier post, the Sub Plinth was Maple that was supported by a Kiln Dried Sand Bed. The sand bed was set up, as a result...
    20 replies | 467 view(s)
  • JohnG's Avatar
    19-05-2019, 12:04
    JohnG replied to a thread isolation blocks in Strokes of Genius
    Looks like Ebony/African Blackwood/Mpingo, all closely related in genus, are offering a positive effect when included as part of a foot.
    20 replies | 467 view(s)
  • JohnG's Avatar
    19-05-2019, 10:44
    JohnG replied to a thread isolation blocks in Strokes of Genius
    I am keen to begin with trialing different materials for isolation feet. I have access to this material in 300mm x 300mm pads, which I was...
    20 replies | 467 view(s)
  • JohnG's Avatar
    19-05-2019, 09:34
    JohnG replied to a thread Sony TTS-8000 Turntable in Analogue Art
    I have searched out Three Items over the Past 2 Years, but not all are searches that have extended back so far. Item one, OTA, fully...
    284 replies | 16309 view(s)
  • JohnG's Avatar
    19-05-2019, 07:33
    JohnG replied to a thread Sony TTS-8000 Turntable in Analogue Art
    It is a very good TT, if the arm is not required and put up for resale there is potentially another 300+ recovered from the sale price. As for...
    284 replies | 16309 view(s)
  • JohnG's Avatar
    14-05-2019, 20:01
    JohnG replied to a thread Sony TTS-8000 Turntable in Analogue Art
    I have set the TT up in the image, so that it shows the two red transit screws properly located. These are usually seen stored in two holes in one...
    284 replies | 16309 view(s)
  • JohnG's Avatar
    04-05-2019, 11:43
    JohnG replied to a thread Just got a 401 in Idle Vice
    Slate is a relatively soft stone. Diamond Tipped Stone Cutting Discs and Tungsten Carbide Jigsaw Blades will allow it to be worked as a DIY Job. I...
    45 replies | 1092 view(s)
  • JohnG's Avatar
    28-04-2019, 10:07
    The Link might help with ideas when considering a enclosure for a Pi. ...
    538 replies | 21457 view(s)
No More Results
About JohnG

Basic Information

About JohnG
Name:
John
Location::
Mildenhall, Suffolk

Statistics


Total Posts
Total Posts
221
Posts Per Day
0.63
General Information
Last Activity
Today 10:12
Join Date
09-06-2018