Adding a second arm to my 930

[BTH K10A]

This adaptor allows the use a of 997 on a 930. It can be sited either where the existing arm is or, on older decks like mine, on the rear left using the mounting holes for the cartridge holder.

I have enquired about converting a spare 929 I have into a 997. Should be just a new arm tube, wiring and heavier counterweight.. I Hope....... :)

If it works out I'll be the proud owner of a "banana" arm. :smoking:

http://i46.photobucket.com/albums/f120/emttsd15/emt930-adaptor_for_emt997_with_connection_box.gif

[Barry]

This adaptor allows the use a of 997 on a 930. It can be sited either where the existing arm is or, on older decks like mine, on the rear left using the mounting holes for the cartridge holder.

I have enquired about converting a spare 929 I have into a 997. Should be just a new arm tube, wiring and heavier counterweight.. I Hope....... :)

If it works out I'll be the proud owner of a "banana" arm. :smoking:

http://i46.photobucket.com/albums/f120/emttsd15/emt930-adaptor_for_emt997_with_connection_box.gif

Who makes it Andy? I would be interested in fitting a 12" arm to my 930, though not a 997.

Regards

[BTH K10A]

Who makes it Andy? I would be interested in fitting a 12" arm to my 930, though not a 997.
Regards

Barry,

Its my usual source for EMT service parts.

http://www.fabtech.de/en_emt-turntables_emt930_adaptor-for-emt997.html

Bear in mind it will be optimised for the 297mm EMT tonearm length.

Regards

Andy