View Full Version : Screwing in the spikes
After a year of ownership I just got round to screwing the little spikes into the bottom of my PMC speakers.
Oh My F***ing God! It's like having different (much better) speakers! Suddenly the bass has appeared and the top end is no longer buzzy. Honestly, it is a very significant difference and it's cost me 40p (the spikes are each standing on 5p pieces so as to not dig into the floorboards).
I feel like a tit for not doing it before.
Should I put some sort of plinth under them too?
S
Stratmangler
06-11-2010, 13:59
I've usually found it beneficial to isolate speakers from suspended floors, so a plinth of some kind would probably be beneficial.
Granite chopping boards are cheap and look nice - I'd give them a go.
Rare Bird
06-11-2010, 14:35
You can't beat castors :lolsign:
I've usually found it beneficial to isolate speakers from suspended floors, so a plinth of some kind would probably be beneficial.
Granite chopping boards are cheap and look nice - I'd give them a go.
This is not my experience and, in the case of the OP, I would remove the 5p pieces and allow the spikes to embed themselves in the floorboards - However, if you have polished floors I quite understand your reluctance to do so and would continue to use small floor protectors (only). Make sure all four spikes make equal floor contact.
petemosby
07-11-2010, 16:58
definitely should be careful with that.
jantheman
08-11-2010, 15:30
I have 15" square paving slabs, painted black, under mine.....£3 each from B&Q......Just a thought....HTH
Reid Malenfant
08-11-2010, 15:53
I have 15" square paving slabs, painted black, under mine.....£3 each from B&Q......Just a thought....HTH
The same sort of thing i use under the equipment in my rack ;) Like yourself i painted them black :eyebrows:
Wickes £2 a slab 400 x 400mm (http://www.wickes.co.uk/Derby-Utility-Paving/invt/224595)
Works a treat :)
hey, why not install a couple of beams going from wall to wall above the current floor? that should isolate them..
michaelhigh
08-11-2010, 22:59
hey, why not install a couple of beams going from wall to wall above the current floor? that should isolate them..
I go from floor to ceiling for overall structural integrity!:lol:
After a year of ownership I just got round to screwing the little spikes into the bottom of my PMC speakers.
Oh My F***ing God! It's like having different (much better) speakers! Suddenly the bass has appeared and the top end is no longer buzzy. Honestly, it is a very significant difference and it's cost me 40p (the spikes are each standing on 5p pieces so as to not dig into the floorboards).
I feel like a tit for not doing it before.
Should I put some sort of plinth under them too?
S
IME, yes.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.