Bridged amp's advice

[diviy]

I am running a Nad 2200 power amp
I have been offered the twin to it so was wondering what advantages if any would I get running the pair in bridge mode .
My speakers are 6 ohm both amps where serviced and recapped at the same time .

[Macca]

it's a 200 watt amp so unless you have some very insensitive speakers or a massive room probably none.

I'd still get it as a spare though.

[diviy]

My room is 26 ft long x12 ft wide.The speakers are againt the wall firing down the room with a 3 seater settee about 12 ft from the speakers .
The speakers are Dali źensor 3s with a Rel Q400E sub in the centre of the speakers.

[Macca]

120 watts will run those speakers to maximum output so I'd say you're good as you are.