FS: Firebottle phono amp with DC2 power supply

[Emmings]

More downsizing.

I've got a Firebottle phono pre-amp up for sale with a Sean Jacobs (Custom Hi-fi) DC2 power supply.

There's a thread on AOS (https://theartofsound.net/forum/showthread.php?26892-FIREBOTTLE-Phono-Preamp) about the phono amp.

The DC2 was built to the specs for the phono amp:

Regulated High Tension supply.
Surge protected dc heaters.
Passive RIAA equalisation.
Frequency response: ------------------------------ wide ---------------------------------
Supply voltage: 12 – 15 volts DC, 1.7A
DC input: 2.5mm DC socket, centre pin positive.
Input impedance: 47 Kohm, 80 pF.
Gain: 44 dB @ 1KHz.
Output impedance: 600 ohms.

Not been used for a while but it was fired up today and all works fine - sounds good too.

I no longer use vinyl which is why this setup is for sale.

https://i.imgur.com/bMEiE8W.png

https://i.imgur.com/vRVHVAd.png

https://i.imgur.com/mPyVxmI.png

https://i.imgur.com/xevjf7b.png

https://i.imgur.com/TNVYreG.png

https://i.imgur.com/pTmgnbt.png

https://i.imgur.com/0Jlkc13.png

https://i.imgur.com/LrCZdud.png

https://i.imgur.com/2AgcjiI.png

Back in 2013 the DC2 was £230 and I think the Firebottle was £230 as well.

I'm asking for £250 delivered.

[Emmings]

Gentle bump...

[Jac Hawk]

is this a pre amp or phono stage, i'm guessing it's a phonostage if so can it be used MM / MC ?

[Westendboy]

Hi Dave, you have pm

[Emmings]

Evening Mike

It's just a phonostage - as to whether it can be used with MM /MC I can't say. I would guess yes since you would just connect a turntable to the unit and then to a pre-amp or integrated amp.

[Emmings]

Mike

Been confirmed by Firebottle that this is MM only.

[Westendboy]

Hi Dave, have sent you another pm

[dgolh]

Hi Emmings, should you have a buyer for the phono amp only, I'd be interested in the power supply.

[Emmings]

Sorry Didier - this is now sold.

[dgolh]

Well done !