View Full Version : Hana ML advice.
Floyddroid
03-12-2021, 05:40
I am just wondering if there are any fellow Hana ML users here who could perhaps give me a little advice? I am just wondering what the optimum impedance settings and gain settings are best with this cartridge. Any tips welcome.:rolleyes::scratch:
Firebottle
03-12-2021, 07:57
Hi Steve, looking at the specs I would say 100 ohm load to start, you could try more afterwards.
Output is 0.4mV so you need a gain setting of 60dB or a bit more. What is you phono stage?
ML needs 100 + if I remember right
Floyddroid
03-12-2021, 16:32
Hi Steve, looking at the specs I would say 100 ohm load to start, you could try more afterwards.
Output is 0.4mV so you need a gain setting of 60dB or a bit more. What is you phono stage?
Cheers Alan. I am using an NJC Reference phono stage at the moment.
I have my ML set at 100 ohms and 70db on my Trichord Diablo and i have to say it sounds alright:)
carruthersesq
07-12-2021, 21:48
Hi Roger
I run mine on my Rega P8 through a Cyrus Signature phono amp at 60db and 330ohms.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.