PDA

View Full Version : LT3045/Battery Regulated Power Supply 5V 2A



brucew268
19-12-2020, 10:16
LT3045/Battery Regulated Power Supply 5V 2A, Four Parallel LT3045 and battery powered

5VDC 2A
Output: 2.1x5.5 plug or screw terminals
Input: battery or 6-8.4v input to screw terminals

Very clean regulated power supply, 4x LT3045 powered by a pair of Lithium 18650 batteries.

Batteries are recharged from supplied SMPS unit in about 3 hours and then should be disconnected. Red LED under front shows when charging. Turns green when charging complete.

Blue LED in back shows when turned on.

Supplied in open-ended, convertible aluminium case that I’ve sourced and fitted.

I also have the metal end pieces and fixings available for the case, and a sheet 5mm Perspex in smoke grey if one wanted to cut transparent end pieces from that.

I purchased the finished board on ebay from a guy in China who was selling to a number of audiophiles around the world who have been rather happy with the results. Nicely refined. It can be supplied by an external DC supply but sounds best from the batteries.

£40, including aluminium enclosure and recharging SMPS
And you don’t have to wait for shipping from China or customs.

290362903529037

brucew268
29-12-2020, 09:19
bump

diviy
31-12-2020, 02:34
Whats the life time if run on batteries please ?

brucew268
31-12-2020, 13:34
As I recall I've been listening about an hour or so a day for 3 days before I need to recharge. So that's probably 3-4 hours use and then 3 hours charging.

Lawrence001
31-12-2020, 16:35
Doesn't the time you get depend on the current drawn? What device is it powering?

Sent from my BKL-L09 using Tapatalk

brucew268
31-12-2020, 16:48
Good point. I generally used it on my DAC which is happy running off a laptop's USB. When powered by an LPS, the mfr recommends one rated for 1-2A. I've not measured its draw directly.