Colin Wonfor
28-11-2020, 23:18
https://scontent-lhr8-1.xx.fbcdn.net/v/t1.0-9/128087964_2471996583103268_9062172395412417133_o.j pg?_nc_cat=111&ccb=2&_nc_sid=730e14&_nc_ohc=AY0LBKX5yR0AX9YTwbx&_nc_ht=scontent-lhr8-1.xx&oh=b07631c6008b249e59c20a540392f26b&oe=5FE6E525
Top left PCB convert Balance to un-Balance,Top right PCB is the twin bridge PSU with 88,000uF Caps and the 12V supply for the Balance PCB and the ON LED drive. The bottom two PCB's are the power Amp, they will be running 35W P-P Class A.
NOTE:- The balance PCB can have a variable gain control not used in this project.
Running the PCB on +20 and _20VDC will allow with larger heat sink a deeper current and more Class A, also note the DC offset can be adjusted to less than 1mV, max current is 12A continuous and 1mS peak current can be over 100Amps. Then the fuse blows.
Great fun on a lock down day.
Top left PCB convert Balance to un-Balance,Top right PCB is the twin bridge PSU with 88,000uF Caps and the 12V supply for the Balance PCB and the ON LED drive. The bottom two PCB's are the power Amp, they will be running 35W P-P Class A.
NOTE:- The balance PCB can have a variable gain control not used in this project.
Running the PCB on +20 and _20VDC will allow with larger heat sink a deeper current and more Class A, also note the DC offset can be adjusted to less than 1mV, max current is 12A continuous and 1mS peak current can be over 100Amps. Then the fuse blows.
Great fun on a lock down day.