Magna Audio
23-05-2020, 18:53
Making a few upgrades for this Sorane SA 1.2 tonearm.
The original armbase didn't allow the arm to go low enough - the armlift pot fouled on the base.
It was also too loose and shallow, so tightening the securing grub screw put it out of alignment.
I've made a close tolerance brass armbase. The arm pillar is now a nice smooth, close fit and much deeper.
The moon shaped cut out to allow the arm to go lower is now in the right place too.
https://uploads.tapatalk-cdn.com/20200523/1b189b2f05e6135cbbd481d9ef4f48db.jpg
https://uploads.tapatalk-cdn.com/20200523/57917f32d5efe31ce3272d561807e814.jpg
[IMG]https://uploads.tapatalk-cdn.com/20200523/e5521c2d467a6ea282b12ae8aa146c07.jpg[/IMG
Sent from my Pixel XL using Tapatalk
The original armbase didn't allow the arm to go low enough - the armlift pot fouled on the base.
It was also too loose and shallow, so tightening the securing grub screw put it out of alignment.
I've made a close tolerance brass armbase. The arm pillar is now a nice smooth, close fit and much deeper.
The moon shaped cut out to allow the arm to go lower is now in the right place too.
https://uploads.tapatalk-cdn.com/20200523/1b189b2f05e6135cbbd481d9ef4f48db.jpg
https://uploads.tapatalk-cdn.com/20200523/57917f32d5efe31ce3272d561807e814.jpg
[IMG]https://uploads.tapatalk-cdn.com/20200523/e5521c2d467a6ea282b12ae8aa146c07.jpg[/IMG
Sent from my Pixel XL using Tapatalk