70s Tannoy Cheviot crossover extraction?

[ponytrekker]

I can see there is a lot of knowledge here about these old things. My question is very basic. How do I get the x-over out?. I have re-foamed the drivers and replaced the feeble terminals, so it would be a shame not to replace the 40-odd year old caps.

[Made in 1968]

4 screws at the bottom behind the little grill

[ponytrekker]

Wot??? The whole thing pulls out from the front?? I was imagining nuts dropping off inside - never to be seen again if I did that, and dislocating my elbow trying to pull the thing out through the driver hole:stalks::stalks: Many thanks.

[Made in 1968]

There should be a mini grill at the bottom that covers the controls. should be four screws around it, X over then comes out the driver hole, unless im thinking of another model

[ponytrekker]

Thanks - got it now I think - I'll report back.

[ponytrekker]

That did it - cheers - nicely made unit.

[Made in 1968]

Sound