apanton1952
17-06-2010, 13:06
My speakers are being packed into storage but I had to prevent the panels slipping (as they do) so after surfin and ruminatin I came up with this recipe:
ingredients
4 of 3mm x 16mm brass woodscrew ( 2 per speaker)
tools
1 x 2.5mm drill bit
1 x hand drill
1 x screwdriver with appropriate bit
process
lay speaker on side
make sure panels in correct position (flush with top and bottom)
position drill bit (I scored a thin line with a pin to assist)
drill hole (refer to picture) at slight angle into base of speaker on one side
screw in screw into hole
panel must rest on screw
repeat on other side
then repeat on other speaker :bulb:
2016
ingredients
4 of 3mm x 16mm brass woodscrew ( 2 per speaker)
tools
1 x 2.5mm drill bit
1 x hand drill
1 x screwdriver with appropriate bit
process
lay speaker on side
make sure panels in correct position (flush with top and bottom)
position drill bit (I scored a thin line with a pin to assist)
drill hole (refer to picture) at slight angle into base of speaker on one side
screw in screw into hole
panel must rest on screw
repeat on other side
then repeat on other speaker :bulb:
2016