PDA

View Full Version : FS ProAc Studio 140 Mk 1



khapahk
24-10-2019, 08:43
After ten years of pleasure from these speakers, I have decided to have a change and these must now go. I'm the second owner of these and they are about thirteen years old in total. As you can see from the photographs there is some sun fading to the left-hand speaker The right -hand speaker has a small dent (10mm)about three quarters of the way up it's left-hand side as you look at it and some minor damage to the top rear edge. They are in full working order and I am happy to demonstrate them. The Studio 140s are quite sensitive; I have been running them very successfully on 7 wpc 300b valve amplification and never found volume to be wanting.

The following information is from the ProAc catalogue :-

Dimensions
Height on plinth with spiked feet 1040mm
Depth 280mm
Width 190mm
Weight 20 kg each with spikes and plinths

Tweeter ProAc 25mm coated silk dome with special coating and inner damping
Bass Driver (Two) 165mm ProAc unit with coated cone, raised spider assembly for greater linearity and large shielded magnet assembly

Grille Acoustically transparent crimplene

Recommended Amplifiers 15-250 watts
Frequency Response 25 Hz - 30 Khz
Nominal impedance – 8 ohms
Sensitivity Nominal Impedance 91db linear for 1watt at 1 metre 4 Ohms

Whilst I have the original boxes (see photo below), this sale is very strictly collection only.

Looking for £375.00 o.v.n.o.


https://imgur.com/BHQgSG2.jpg

https://i.imgur.com/D3G0Jod.jpg

https://i.imgur.com/T9mOMwj.jpg

https://i.imgur.com/ZXuZq62.jpg

https://i.imgur.com/yJxOSGd.jpg

https://i.imgur.com/byxdPOI.jpg

https://i.imgur.com/KD5qXde.jpg

https://i.imgur.com/5wggvLH.jpg

Jazid
24-10-2019, 08:55
Best to add where you are located [emoji106] unless I missed it....

Sent from my BLA-L09 using Tapatalk

khapahk
24-10-2019, 09:21
Best to add where you are located [emoji106] unless I missed it....

Sent from my BLA-L09 using Tapatalk


I assumed that the Location info in the name bar at top of the post would be OK ! :)

To avoid any doubt I'm located in Linslade, Bedfordshire.

hifibuff68
24-10-2019, 09:54
If still available, I would like to take them off of your hands please ?

Could you PM me to iron out collection details etc

Thanks

khapahk
24-10-2019, 10:03
If still available, I would like to take them off of your hands please ?

Could you PM me to iron out collection details etc

Thanks

PM sent.

khapahk
25-10-2019, 07:48
Sold subject to payment/collection.