Rega tonearm swap ~ simple advice needed please!

[Bamby]

Hi,
Thanks for looking ...

I want to swap over an RB250 pillar/collar fixing from a Michell Syncro to a Roksan Radius mk1with a RB100 with 3 point fixing.

... Then l want to put the RB100 on the Syncro.

Advice much appreciated please!
l guess there's a Rega expert out there?

Thanks, Paul

[hifi_dave]

Fitting an RB250 to a turntable with the later 3-point fix is just a matter of putting it in't hole and tightening up the screw collar. Geometry is the same.

[YNWaN]

Dave should know as he’s sold enough but, just to iterate, he’s quite right. Going in the other direction you need to add the three screw holes.

[Bamby]

Thank you guys.
Just needed that moral support beforehand!

lf l need spacers, l shall go to Radlett! :)