Help with a Rega planar motor

[Jac Hawk]

Hi guys,

As some of you know I'm upgrading my old Planar 3, at the moment I'm upgrading the plinth and decoupling the motor and mounting it on a sub plinth, problem is I'm not sure if the motor or pcb is buggered I have a soldering iron but I don't have a multimeter to check everything out, is there anyone in the Chorley area that could help me?

[CornishPasty]

I'm near Accrington, ten minutes off J7 M65 if I can help JH.

[Light Dependant Resistor]

Hi guys,

As some of you know I'm upgrading my old Planar 3, at the moment I'm upgrading the plinth and decoupling the motor and mounting it on a sub plinth, problem is I'm not sure if the motor or pcb is buggered I have a soldering iron but I don't have a multimeter to check everything out, is there anyone in the Chorley area that could help me?

Hi Mike
Important information here that is essential for any repair or upgrading: https://www.vinylengine.com/library/rega/planar-3.shtml , maybe that will help
Hope one of the other members can help you with a multimeter, as I am in New Zealand.

[Jac Hawk]

Cheers Ralph, I'll ping you a PM and we can arrange something if that's ok

[CornishPasty]

That's fine JH.