Wanted: stylus guard

[montesquieu]

Wanted: stylus guard ... Something like the metal one on a Denon 102 - I know it's a long shot but anyone know where I can get hold of one? There were some available years ago on the Lenco forum but not any more, and some were done for the Midas cartridge bodies.

Anyway a pic .. something like this:

http://soundgate.net/upload/save_image/11230426_5a16cc9b56310.jpg

[STD305M]

Hi Tom

The guard looks almost the same as the one on my at33ptg.
Regards Steve...

[rockhopper]

Wanted: stylus guard ... Something like the metal one on a Denon 102. There were some available years ago on the Lenco forum but not any more, and some were done for the Midas cartridge bodies.

Anyway a pic .. something like this:

http://soundgate.net/upload/save_image/11230426_5a16cc9b56310.jpg

The Midas bodies and guards were made by David Wong in Hong Kong who was on the Lenco forum. I have an email from 3 years ago when he said that he usually charges $35 per guard but offered 4 for $100 inc. shipping.
I can pm you his contact details if interested.
These guards are also good on Micro Benz cartridges which come without any protection.
R.

[montesquieu]

The Midas bodies and guards were made by David Wong in Hong Kong who was on the Lenco forum. I have an email from 3 years ago when he said that he usually charges $35 per guard but offered 4 for $100 inc. shipping.
I can pm you his contact details if interested.
These guards are also good on Micro Benz cartridges which come without any protection.
R.

Sounds ideal Russell yes please PM. I did contact him via Lenco forum PM but I didn't get a reply.

[Len Co]

I'm sure I could make one out of this bit of springy scrap metal - came out of a cheap scart plug I think.
(Surely a simple U section would be good enough too, no need to shape it quite so much around the stylus)
http://i65.tinypic.com/2r5ua84.jpg

[montesquieu]

PM incoming Mark :)