Please help me clean switches on my lovely Nak CA-5

[Mikeandvan]

So I use this slim line lovely as a phono stage. Some of the switches are a little bit fuzzy when turned (when I use it in pre amp stage obviously). So I got me Servisol Super 10, but I can't see an obvious place to spray it. Hopefully these pics will help someone explain to me. Ta.

https://farm5.staticflickr.com/4724/26150619708_93c1972a17_z.jpg (https://flic.kr/p/FQQLaA)IMG_20180131_232810397 (https://flic.kr/p/FQQLaA) by Mike Van (https://www.flickr.com/photos/145505522@N02/), on Flickr
https://farm5.staticflickr.com/4697/39125525235_79f03acc8d_z.jpg (https://flic.kr/p/22Boxxi)IMG_20180131_232731429 (https://flic.kr/p/22Boxxi) by Mike Van (https://www.flickr.com/photos/145505522@N02/), on Flickr
https://farm5.staticflickr.com/4711/28244371829_4775525a80_z.jpg (https://flic.kr/p/K2RMJ6)IMG_20180131_232652947 (https://flic.kr/p/K2RMJ6) by Mike Van (https://www.flickr.com/photos/145505522@N02/), on Flickr

[Bigman80]

If it's PCB Mounted, you're gonna have to take them off or spray where you can and hope some gets in!!!!!

[mikmas]

the Alps pots I own have two small holes in the side of the casing - squirt in there (aided by the thin plastic tube you got with the Servisol?)

Failing that, squirt where the knob shaft goes into the barrel. Doesn't take much - just a brief burst.