View Full Version : DIY Crossfeed controller device for speakers
maxrob200
30-08-2017, 03:23
Has anyone had positive experience with using Crossfeed devices for speakers instead of headphones? The Taket Sound Activator device appears to be a crossfeed control unit and I am wondering if there are any DIYers on the forum who has built such a unit. The Taket is 150 GBP so I am looking for a cheaper alternative as an experiment to see whether crossfeeding is worthwhile for speakers. Witchdoctor.nz has a positive review of the Taket SA.
There was a thread on Rock Grotto forum some years ago about a DIY Meier crossfeed for headphones. I bought a pcb to make one and never got around to it. I understand that this is a passive unit that you plugged your headphones into and then into a head amp. I assume that for speakers it would require an active unit to process the incoming signal rather than it being placed between speakers and amp?
maxrob200
31-08-2017, 02:46
the taket SA device is passive and connects to the + terminals of the speaker outputs (L and R channel)
walpurgis
31-08-2017, 08:11
Not sure why somebody would wish to compromise stereo imaging.
I did experiment years ago with a version of the Hafler speaker 'ambient' circuit that uses a centre speaker with an 'L' pad, fed from both left and right + outputs from the amp. This achieves the same end. Results made me decide it was not worth bothering.
RothwellAudio
31-08-2017, 09:19
I understand that this is a passive unit that you plugged your headphones into and then into a head amp.
I think you mean a headphone amp. A head amp is preamp which is (usually) placed close to the transducer it's amplifying, such as inside a condenser microphone. In a hi-fi context the term head amp usually refers to a preamp for LOMCs, placed between the cartridge and phonostage.
I think you mean a headphone amp. A head amp is preamp which is (usually) placed close to the transducer it's amplifying, such as inside a condenser microphone. In a hi-fi context the term head amp usually refers to a preamp for LOMCs, placed between the cartridge and phonostage.
Yes, you are of course right. I have upped my daily dosage of Aricept:lol:
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.