Technics Pitch Slider

[Dubster68]

Just need to know about the pitch slider decals. Are they a replacement part or are they a vinyl transfer. Mine has a few marks and scratches so wanting to change it. The pitch slider is fine and fully working.

[chiz]

This looks to be the factory part you need, hopefully you can find it cheaper than this though:
http://www.ebay.co.uk/itm/Technics-Black-Pitch-Trim-Display-Board-Sticker-SL-1210-MK2-M3D-MK3-RGH0131-2K1-/151080776457

[Dubster68]

So it is just a transfer as standard. Say a few on eBay a little cheaper so will have a look. Cheers for that Chris:D

[chiz]

You're welcome Mick. Be aware that the cheaper ones may not be the original Technics factory part and quality may vary.
Looks like KAB still have the originals for $9.95 which should duck customs charges but I don't know how much the shipping will cost:
http://www.kabusa.com/m1200.htm#pitch

[Dubster68]

Thanks Chris. I think I will go for the original ones. I know prices are highly but at least you know what you are hopefully getting:thumbsup:

[Cycleallday]

So it is just a transfer as standard. Say a few on eBay a little cheaper so will have a look. Cheers for that Chris:D

Its not a transfer Mick - its a metal stick on part. Just taken one off a deck I am refurbing and have ordered the Technics part from BopDJ - did not find it any cheaper elsewhere.

Mel

[Dubster68]

Its not a transfer Mick - its a metal stick on part. Just taken one off a deck I am refurbing and have ordered the Technics part from BopDJ - did not find it any cheaper elsewhere.

Mel

Thanks Mel

Just ordered one but could only find an original silver one. Will see how that looks on a black deck. If it looks wrong I can always remove it as it was only £6 delivered..


Sent from my iPhone using Tapatalk Pro

[Cycleallday]

Take care when removing the old one as it can be a bit of a pig to get off without damaging the existing paint work around the edges. I suggest you find a thin blade pointed knife and lift one corner to start with. Put a credit card or something similar between the blade and deck when first levering/lifting it - it worked for me. Once one corner is up then used some long nose pliers to peel it off. Its a bit like opening a sardine can and the glue on mine didn't want to let go !.

[RobbieGong]

And in all seriousness, careful with that blade.

[Idlewithnodrive]

Thanks Mel

Just ordered one but could only find an original silver one. Will see how that looks on a black deck. If it looks wrong I can always remove it as it was only £6 delivered..


Sent from my iPhone using Tapatalk Pro

If it doesn't look right Mick, let me know, as I think I still have a new Black Technics one kicking aroundi in a spares box that you can have for £6 delivered.

[Dubster68]

If it doesn't look right Mick, let me know, as I think I still have a new Black Technics one kicking aroundi in a spares box that you can have for £6 delivered.


I have put the silver one on and it doesn't look bad. I would still be interested in the black one if new and original.

PM sent Mike