Magna Audio
29-11-2009, 18:18
Fed up with your Foculpod feet not staying on deck when you move it?
A few mins and that problem was sorted.
http://inlinethumb38.webshots.com/37349/2647065760071997495S600x600Q85.jpg (http://entertainment.webshots.com/photo/2647065760071997495BPkqlJ)
M6 threaded bar, Superglue and... the magic ingredient.
http://inlinethumb26.webshots.com/44761/2862095860071997495S600x600Q85.jpg (http://entertainment.webshots.com/photo/2862095860071997495ZqeWFk)
A 1941 Southbend 9" lathe.
Careful to seat the Foculpod true in the chuck / jaws. Drill her out with a 4.5mm sharp drill - seats nicely around the thread.
Then a bit of super glue and sorted.
http://inlinethumb54.webshots.com/42613/2057434800071997495S600x600Q85.jpg (http://entertainment.webshots.com/photo/2057434800071997495YNvJzS)
The threaded bar is set 8mm into the Foculpod. Plenty of pod left for all it's acoustic damping magic to work.
They screw up into the thread nicely seated with a little easing of the edges as usual.
They really do stay put too!
A few mins and that problem was sorted.
http://inlinethumb38.webshots.com/37349/2647065760071997495S600x600Q85.jpg (http://entertainment.webshots.com/photo/2647065760071997495BPkqlJ)
M6 threaded bar, Superglue and... the magic ingredient.
http://inlinethumb26.webshots.com/44761/2862095860071997495S600x600Q85.jpg (http://entertainment.webshots.com/photo/2862095860071997495ZqeWFk)
A 1941 Southbend 9" lathe.
Careful to seat the Foculpod true in the chuck / jaws. Drill her out with a 4.5mm sharp drill - seats nicely around the thread.
Then a bit of super glue and sorted.
http://inlinethumb54.webshots.com/42613/2057434800071997495S600x600Q85.jpg (http://entertainment.webshots.com/photo/2057434800071997495YNvJzS)
The threaded bar is set 8mm into the Foculpod. Plenty of pod left for all it's acoustic damping magic to work.
They screw up into the thread nicely seated with a little easing of the edges as usual.
They really do stay put too!