PDA

View Full Version : How do you know how long you've used your cartridge for?



Clive197
09-04-2016, 13:28
This is not a question about how long will the stylus last but how do we know how many hrs the stylus has.

I would bet that nobody on here uses a timer that you turn on/off every time you listen to a record (maybe that's a good idea).

We have ALL quoted hrs when we sell, replaced or bought a s/h cartridge but how accurate is that information? Is it important?

Back in the day when I used MM cartridges, I replaced the stylus annually. I'm sure I wasted my money doing that but I did not want to damage my vinyl and got quite anal about it.

struth
09-04-2016, 13:31
Lot of folk use clickers that count sides. I,m not that fussed but some of the old ones are rather quaint

Barry
09-04-2016, 13:58
I just examine the stylus with a 60x eyepiece about once a month. You used to be able to buy a counter (think it was made by Colton) that was activated by the cartridge magnet.

Alternatively you can estimate the hours used by assuming each LP played uses 2/3 hour of stylus lifetime. So if you play three LPs a night, that's 14 hours a week, 60 hours a month or 720 hours a year.

RobbieGong
09-04-2016, 13:58
I think most people quote an approximate based on a calculation of roughly how many hours they spin vinyl each week or month etc. For most of us it's the only way.

struth
09-04-2016, 14:22
http://www.ebay.co.uk/itm/Hand-CLick-Counter-Tally-Recorder-Logger-Counting-Counts-Clicker-/151303610834?hash=item233a65e1d2:g:IVMAAOxyCTtTdL~ x

This sort of thing..the older onesxwere much better

Macca
09-04-2016, 14:32
Wasn't there a Jap deck that kept track for you? Can't remember who made it.

Barry
09-04-2016, 14:32
http://www.ebay.co.uk/itm/Hand-CLick-Counter-Tally-Recorder-Logger-Counting-Counts-Clicker-/151303610834?hash=item233a65e1d2:g:IVMAAOxyCTtTdL~ x

This sort of thing..the older ones were much better

Can't complain for less than a fiver.

Nigel
09-04-2016, 14:50
Everytime I listen to a side, I mark it down. I tick a box on a piece of paper which I've placed a load of squares on. I work on the average of twenty minutes a side. So three sides equal an hour. Sad man that I am I could tell you how many LP sides my cartridge has played.

walpurgis
09-04-2016, 15:06
Does it matter? I used a Technics EPC-305MC as my main cartridge for about thirty years. No idea how many thousands of hours were on it. It was always tracked at 1.75 grams and when inspected under a microscope the elliptical diamond tip showed no wear.

Simon_LDT
09-04-2016, 15:10
I literally just note it down. I've got a spreadsheet with all my LP's on and I make a note of any issues upon first playthrough. Plus I make note if it has been cleaned on my RCM (new feature for me since I got one recently). After each session of LP playback I just add the relevant no. of hours. Say if I had a session from 7pm-10pm, I'll add 3 hrs to stylus use, even though techincally I might have only played 2 1/2 hrs worth. That gives some leeway and I'd rather over-estimate than under.

Sad, I know. :D

Beobloke
09-04-2016, 15:11
Wasn't there a Jap deck that kept track for you? Can't remember who made it.

The Garrard Zero 100S had a counter that advanced a small amount up a scale on the bearing housing each time the arm moved towards the record.

Wntrmute2
09-04-2016, 15:50
16636

This is how I do it. The Hammond enclosure houses a hour meter as well as the needle valve and connectors for adjusting air pressure for the Trans-Fi Terminator tonearm. The hour meter is plugged into a socket that is energized whenever the turntable is spinning so it overestimates a bit.

petrat
10-04-2016, 07:22
Separate tally counter for each cartridge, with each side 'clicked' the total is approx 3x the hours played ...

http://www.amazon.co.uk/RelX-Handheld-Tally-Counter-Digit/dp/B000I6R1PS/ref=sr_1_1?s=sports&ie=UTF8&qid=1460272816&sr=1-1&keywords=clickers