FS: Pair of KEF B200.A SP1014 drivers in KEF box.

[Arkless Electronics]

I've had these laying about for years and can't even remember where I got them from.... They are, as the title says, a pair of KEF B200.A SP1014 bass/mid drivers in a "KEF Constructor Series" box with a template for cutting out the required mounting hole.
They appear to be unused (no mounting screw marks etc) but I must point out that the driver on the left in the photos has some small marks on the bextrene cone. See photos. The voice coils measure correct as 8 Ohm units, they play when connected to my hifi and I've tried them with 20Hz sine wave from signal generator and they don't appear to be rubbing or any other obvious issue. Other than that I know sweet FA about them so they are "sold as seen". £50 delivered.

http://i1303.photobucket.com/albums/ag156/Jez1235/SDC10719_zpswmnjbfks.jpg?1446660758704&1446660760498&1446660766439&1446660779353

http://i1303.photobucket.com/albums/ag156/Jez1235/SDC10727_zpskdtam5yq.jpg?1446660758698&1446660760481&1446660766434&1446660779342

[sumday]

they look like the huge magnet version used in kef kalinda's and the bigger imf's.

good luck with the sale.

NIGE.

[Arkless Electronics]

they look like the huge magnet version used in kef kalinda's and the bigger imf's.

good luck with the sale.

NIGE.

Actually they're a small magnet version! I guess the angle of the photo makes the magnet look much bigger than in real life... These have "KEF Constructor Series" on the side of the box so I guess they were packaged for sale to DIY speaker builders. Like I said in the op I really know nothing about them other than someone gave them to me maybe 20 years ago (I can't remember who, I'm ashamed to say!) and I've had them laying around ever since.... Christ knows how the marks got on one of them but they were like that when I got them. The lid to the box has some doodles on it of speaker cabs but as there are no marks from fixing screws, no old solder on the terminals (other than where the lead out wires were attached on the other side of the terminals by KEF of course) and the template hasn't had the middle pushed out to use it, I'm guessing however first bought them never got round to building his DIY speakers!

[Arkless Electronics]

Bump