diceman
25-03-2015, 13:57
Pass diy Buffer DC coupled version of B1 built from PCB from diyaudio and incorporating 3 inputs and 1 output.
A buffer provides no gain but increases current to drive the power amp and/or long interconnects. Effectively a passive preamp with balls and a best of both worlds if you don't need gain.
Nicely built with some nice components and incorporates Alps Blue pot, relay switched input, nice case and additional PSU cap board.(it can be modded to add 2 more inputs by adding some wire and phono sockets and using the other 2 relays not currently in use.)
It is half width so 225mm W x 300mm L x 110mm H
Adds very little and takes very little away from the signal. lovely item that will compete with some expensive pre-amps out there.
Only selling as I have built a cost no object version.
Asking £240 + P&P or pick up at the pieshow/collect from Surrey/Hampshire border
http://i160.photobucket.com/albums/t187/diceman200/dcb1%20front_zpswofvwm5y.png (http://s160.photobucket.com/user/diceman200/media/dcb1%20front_zpswofvwm5y.png.html)
http://i160.photobucket.com/albums/t187/diceman200/DCB1%20lid%20off_zps4fajxpti.png (http://s160.photobucket.com/user/diceman200/media/DCB1%20lid%20off_zps4fajxpti.png.html)
http://i160.photobucket.com/albums/t187/diceman200/dcb1%20rear_zpstmbypqcy.png (http://s160.photobucket.com/user/diceman200/media/dcb1%20rear_zpstmbypqcy.png.html)
A buffer provides no gain but increases current to drive the power amp and/or long interconnects. Effectively a passive preamp with balls and a best of both worlds if you don't need gain.
Nicely built with some nice components and incorporates Alps Blue pot, relay switched input, nice case and additional PSU cap board.(it can be modded to add 2 more inputs by adding some wire and phono sockets and using the other 2 relays not currently in use.)
It is half width so 225mm W x 300mm L x 110mm H
Adds very little and takes very little away from the signal. lovely item that will compete with some expensive pre-amps out there.
Only selling as I have built a cost no object version.
Asking £240 + P&P or pick up at the pieshow/collect from Surrey/Hampshire border
http://i160.photobucket.com/albums/t187/diceman200/dcb1%20front_zpswofvwm5y.png (http://s160.photobucket.com/user/diceman200/media/dcb1%20front_zpswofvwm5y.png.html)
http://i160.photobucket.com/albums/t187/diceman200/DCB1%20lid%20off_zps4fajxpti.png (http://s160.photobucket.com/user/diceman200/media/DCB1%20lid%20off_zps4fajxpti.png.html)
http://i160.photobucket.com/albums/t187/diceman200/dcb1%20rear_zpstmbypqcy.png (http://s160.photobucket.com/user/diceman200/media/dcb1%20rear_zpstmbypqcy.png.html)