Which Pro Amp for bi-amping the bass on my JBL4344's?

[Val33]

I'm after some suggestions for a suitable amplifier to use on the bass section of my JBL4344's. I'm going to try active bi-amping, using my PP 300b's for the mid/top. I've been looking for an MC2 MC450 but they seem in short supply.

I think my requirements are minimum of 200w @ 8ohm, high damping factor, low noise or no fans, Budget is around £500.

Anyone with experience of pro gear care to make any suggestions?

Thanks

Val

[wee tee cee]

Val,
Behringer a500 can be run as monos...plenty of bang for your buck?

[YNWaN]

I've used a Lab.gruppen IPD 1200 on mine - 600wpc into 8 Ohm, 1200 into 4 Ohm - active digital crossover built into the front end which is extremely flexible - works super well. It does have a fan, but its noise is masked even in very quiet passages. The biggest negative is that it's nearly twice your budget.

[John]

The Behringer Inuke would fit the bill but you need to put a resistor in the fan circuit or change it to something quieter. Has DSP which gives you the control you need. 3 different models to choose from. Most pro gear is going to have a fan.

[Val33]

Thanks for the info

Just to clarify, I don't need the processing, I have that covered. I am also ok with fans, so long as they are quiet!

Just looking for ideas as to what brands/models are worth looking at.

Val

[smithy]

Maybe a Crown K1 or K2,I use a K2 for bass duties and a MC2 650 for mids, SET for tops.