sumday
21-04-2014, 19:27
my nad 3120 is currently driving q 2050i speakers which are a nominal 6 ohm load.
the load switch is currently set at 4 ohms...is this too low or is the 8 ohm setting too high...or is there no difference??
the amp is stock apart from a good hovering and cleaned fuses!!!
ohh...and a missing switch button!!
nige.
the load switch is currently set at 4 ohms...is this too low or is the 8 ohm setting too high...or is there no difference??
the amp is stock apart from a good hovering and cleaned fuses!!!
ohh...and a missing switch button!!
nige.