twelvebears
15-06-2009, 17:24
OK guys (out of curiosity, are there actually and ladies on AOS?), couple of questions for the collective brain:
First question: are soldered or mechanical electrical connections best?
Gut and brain say (assuming it's not botched) that a soldered connection is better but I wanted views. Reason for asking is that my Volt bass drivers use hefty pro-style spring connections which look identical to the ones used on ATC drivers. Thus far, I've always used these, but I'm now wondering if I should solder instead. Doing so would be easy and wouldn't present any danger to the voice-coil.
Second question: at some point, I may wish to experiment with active crossovers (not for a while however) and was wondering if anyone had played around with this themselves? There are several companies who produce pre-built, adjustable crossovers where you can play with the frequency, roll-off rates and system Q.
Although I own a MF M3 integrated, the pre and power sections are actually connected internally using proper phono leads and it also has pre-outs, so introducing an active crossover would be quite easy assuming I can find a matching amp to partner it, so suggestions on the latter two if you have any.
Thanks in advance for your input.
First question: are soldered or mechanical electrical connections best?
Gut and brain say (assuming it's not botched) that a soldered connection is better but I wanted views. Reason for asking is that my Volt bass drivers use hefty pro-style spring connections which look identical to the ones used on ATC drivers. Thus far, I've always used these, but I'm now wondering if I should solder instead. Doing so would be easy and wouldn't present any danger to the voice-coil.
Second question: at some point, I may wish to experiment with active crossovers (not for a while however) and was wondering if anyone had played around with this themselves? There are several companies who produce pre-built, adjustable crossovers where you can play with the frequency, roll-off rates and system Q.
Although I own a MF M3 integrated, the pre and power sections are actually connected internally using proper phono leads and it also has pre-outs, so introducing an active crossover would be quite easy assuming I can find a matching amp to partner it, so suggestions on the latter two if you have any.
Thanks in advance for your input.