Isotek Substation Mains Conditioner (fully loaded)

[daws0n]

A few minor scratches present but overall condition is good - this is the fully loaded variant, configured as follows:

1 x 600va transformer (2 shared sockets)
1 x 150va transformer (2 shared sockets)
6.3a filter module (2 shared sockets)

Retailed at around 2k new, this isolation transformer based mains conditioner really does the business unlike cheaper alternatives I had before hand. I upgraded from a Belkin PF40 which is no slouch in it's own right and found it to be a considerable improvement.

£399 + delivery at cost (I am guessing £20 tops)

http://www.dawsonspace.webspace.virginmedia.com/ebay/isotek.jpg

[joker]

This might be a dumb question, but can you tell me which products you would typically connect to which socket?

[daws0n]

The choice is yours mate it's mostly for source components but I ran my whole system from it with no problem. Decided however that due to the high wattage the power amp was better suited running from my wall outlet. The 600va transformer is perfectly adequate to driver a small amplifier though.

Isotek's rule of thumb is to isolate digital and analog components and try not to run them off the same outlet if possible.

At present it powers the computer+screen, CD player, pre amp and DAC.

[daws0n]

morning bump

[daws0n]

Bump.

[daws0n]

bump

[daws0n]

Bump. Now £395 inc. delivery