Wanted: Linn LP12 + arm

[Colin151]

Sold my LP12 a while back and have been hankering after another.

I’d ideally like a post 70,000 serial LP12 (due to them having the better black inner bearing and corner braced plinth), but will consider earlier ones too.

Would prefer an Ittok arm, but would also consider others.

Cartridge included would be welcome but not totally necessary.

PSU wise: Must be Valhalla model at least.

If you have any suitable LP12 + arm combo then please let me know.

Cheers,
Colin

[vinylspinner]

Hello Colin,

I have an LP12, cirkus bearing etc with Ittock arm and Heed Orbit off board power supply, fitted with Denon DL304 cartridge, very very clean condition, looking for £950 ovno.

Nigel

[DSJR]

Ittoks go for a good few hundred quid and the Cirkus replaced loads of iffy bearings (a long standing issue up to the mid 80's with thrust pad hardening not being consistent across its surface) Well worth £950 if you can collect it, remove the top platter and pack under the inner platter to stop the suspension from going awry. The counterweight will stand a careful car journey in situ, but obviously not via courier.....

Grab it I say!!!!!

[Colin151]

Thanks Guys,
Only just seen your replies now. Will get on it!

Cheers,
Colin