View Full Version : Anti-Vibration Mounts
Rare Bird
30-12-2012, 15:15
Does anyone know a source where i can just buy a few of these 1/2'' diameter, must be male to female M5
All I can think of in the first instance is RS Components mate. They do have a substantial mechanical engineering section and just might have something similar...
Sonority
30-12-2012, 16:51
You may get something close with your local motor factors.
Fuel pump mounting *used* to be like that - at least on early Astra GTE.
I have used mini engine mounts, exhaust mounts and all sorts during searches :)
Good luck.
The Grand Wazoo
30-12-2012, 19:53
Try a Stihl and/or Husquvarna chainsaw dealer - they look just like the things they use do isolate the vibes of the engine and drive train from the poor sod holding the handles.
Nonnegativ
30-12-2012, 20:21
And please let us know if you are successfull in finding these..
walpurgis
30-12-2012, 20:59
Something like these Andre?
http://www.ebay.co.uk/itm/261132998165?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
http://www.ebay.co.uk/itm/130337893511?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
Rare Bird
30-12-2012, 21:01
They are em Geoff but they have to be 13mm diameter, they are to fit inside the Lenco motor mount..
walpurgis
30-12-2012, 21:08
They are em Geoff but they have to be 13mm diameter, they are to fit inside the Lenco motor mount..
You could actually trim them on a lathe, the rubber should cut OK at a high speed.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.