Haselsh1
19-01-2009, 09:37
As you can see here, I use a Linn Basik with an Alphason Xenon MCS tonearm which, in reality, I'd quite like to keep. So, with that in mind, I've been thinking about constructing a new plinth for the Linn.
The new plinth with be square instead of the usual rectangle and will be made from one inch thick plywood in the form of two inch frames. Three of these will be bonded together along with a top plate to form a hollow plinth around four inches thick. The top plate will carry the holes for the motor, the bearing housing and the arm.
The plinth will finally be finished in matt black with spun aluminium fittings. Has anyone any advice...???
The new plinth with be square instead of the usual rectangle and will be made from one inch thick plywood in the form of two inch frames. Three of these will be bonded together along with a top plate to form a hollow plinth around four inches thick. The top plate will carry the holes for the motor, the bearing housing and the arm.
The plinth will finally be finished in matt black with spun aluminium fittings. Has anyone any advice...???