SME 3009R problem

[Robin]

I've just fitted a 3009R on my TD 150, adjusted the suspension, got it bouncing nicely and all levelled but the arm keeps swinging to the right, away from the spindle no matter what I do. Adjusting the lateral balance helps a little but does not get rid of the problem. I'm at a loss (and rather disappointed as I've been looking forward to putting the new arm on). Anyone got any bright ideas here?
Thanks in advance.

[hifi_dave]

Have you got the bias/anti skate fitted ?

If you have, then remove it whilst setting up.

[Robin]

No, not fitted while setting up. Followed the set up instructions to the letter....

[rusty bearing]

I found that by cleaning the spot under the arm that rests on the lift and the lift surface itself this could be kept to a minimum. Also reduced the Anti-skate value a little, definitely a balancing act

[Robin]

Got there in the end. The internal arm wire was twisted and after much poking around everything is sorted. Thanks for you suggestions, chaps!
Sounding very nice too now I might add.