Ammonite Audio
21-01-2012, 15:06
This is an almost new Dynavector DV-20X2L bought recently from Analogue Seduction (http://www.analogueseduction.net/product/Dynavector_DV-20_X2_Moving_Coil_Cartridge_DYN-DV20X#) for £499. It has less than 40 hours on it and is in perfect order with all original packaging and accessories.
http://www.dynavector.com/products/images/20X2_400w.jpg
Specifications are:
Low output moving coil cartridge with flux damper and softened magnetism
Output Voltage 0.3mV (at 1KHz, 5cm/sec.)
Channel Separation 25 dB (at 1KHz)
Channel balance 1.0 dB (at 1KHz)
Frequency response 20 - 20,000Hz (± 2dB)
Compliance 12 x 10-6 cm/dyn
Tracking force 1.8 - 2.2grams
DC resistance 5 ohms
Recommended load
resistance 30 ohms
Cantilever 6mm length, hard aluminium pipe
Stylus Micro-Ridge
Weight 9.2 grams
It was bought as a battle casualty replacement for my Benz Glider SL, and is very nice in itself, very quiet in terms of tracking and surface noise. I'm selling it because it's perhaps a bit too refined and polite for my tastes after the Benz.
.
Yours for £325 including postage
http://www.dynavector.com/products/images/20X2_400w.jpg
Specifications are:
Low output moving coil cartridge with flux damper and softened magnetism
Output Voltage 0.3mV (at 1KHz, 5cm/sec.)
Channel Separation 25 dB (at 1KHz)
Channel balance 1.0 dB (at 1KHz)
Frequency response 20 - 20,000Hz (± 2dB)
Compliance 12 x 10-6 cm/dyn
Tracking force 1.8 - 2.2grams
DC resistance 5 ohms
Recommended load
resistance 30 ohms
Cantilever 6mm length, hard aluminium pipe
Stylus Micro-Ridge
Weight 9.2 grams
It was bought as a battle casualty replacement for my Benz Glider SL, and is very nice in itself, very quiet in terms of tracking and surface noise. I'm selling it because it's perhaps a bit too refined and polite for my tastes after the Benz.
.
Yours for £325 including postage