WTD.For Quad 66 Pre.

[peter j]

Looking for a pair of MM(3mV) phono boards for a Quad 66 Pre-Amp.These are the ones that were supplied as standard and you then had to purchase MC versions as required.The part No. is Q66DMKM.

[Bigandbouncy]

Peter, I don't know if these are any good for you. They are Q66MMIM.
Dave

http://i1127.photobucket.com/albums/l629/Bigandbouncy/th_DSC00776.jpg (http://s1127.photobucket.com/albums/l629/Bigandbouncy/?action=view&current=DSC00776.jpg)

[peter j]

Hello Dave,
Thanks for your reply.I have looked at the values of the caps and resistors on your beautifully clear picture and they tie in with a schematic I have of the boards that I need.I don't know why the part Nos. are different to the numbers that I have found but the description of 3mV 47k 220pF is certainly matching.

I have just done a bit more research since starting this reply and I have found out that the version you have are the RIAA type.I'm even more confused now because I thought that the RIAA standard was on the part No. that I quoted in the original post.
Anyhow the only question now is how much do you want for them as I'd like to give them a try? I have given up hope of finding my original boards which is not too surprising considering the changes of equipment over the years since I bought the 66.
Thanks again, Peter.

[Bigandbouncy]

Peter, knowing the guy these came from, they will have been experimental, expensive and unusual. Send me your address and I'll send them out to you and you can give them a go, If they are no good for you, just send them back, if they are what you are after then make a nice donation to my charity - whatever you think is reasonable :-)
Dave

[peter j]

Thanks Dave,
You have e-mail.
Peter.

[peter j]

Hi Dave,
More e-mail on the way.
Peter.

[peter j]

All done Dave.
Many thanks for the deal.
Regards, Peter.