Bakoon 13r Denon DP80 Stax UA-70 Shure Ultra 500 in a Martin Bastin body with jico stylus, project ds2 digital Rullit aero 8 field coils in tqwt speakers
Office system, DIY CSS fullrange speakers with aurum cantus G2 ribbons yulong dac Sony STR6055 receiver Jvc QL-A51 direct drive turntable, Leema sub. JVC Z4S cart is in the house
Garage system another Sony receiver, cassette deck
System components are subject to change without warning and at the discretion of the owner.
Location: Shrewsbury
Posts: 78
I'm Michael.
Could anyone tell me if the Zeta uses the Jelco JL-45 TONEARM LIFT or whether it fits the Zeta.
Edit - I've found some measurements so I'll measure the old one. Meanwhile if anyone does happen to know...
Location: Derbyshire
Posts: 542
I'm mark.
Location: Derbyshire
Posts: 542
I'm mark.
Just one for now
IMG_4264 by mark leatherland, on Flickr
I've changed too much recently to assess much, I swapped an Artemiz onto the Delphi and thought its clean/lean bass suited better, but I rate the Artemiz as probably the best arm I've got (J7 Incognito re-wire). Need to make an armband for the Mechanic to fit on a Garrard for more assessment, nevertheless the Mechanic is a thing of beauty, hard and heavy with a black chrome finish.
Last edited by DiveDeepDog; 08-05-2018 at 19:54.
Location: Derbyshire
Posts: 542
I'm mark.
Its new home, may be here a while
IMG_4303 by mark leatherland, on Flickr
mark,
I'm delivering a Paradise tonight. I'll forward on those resistors tomorrow. Sorry for the delay.
Kuzma Stabi/S 12", (LP12-bastard) DC motor and optical tacho psu, Benz LP, Paradise (phonostage). MB-Pro, Brooklyn dac and psu, Bruno Putzeys balanced pre, mod86p dual mono amps, Yamaha NS1000m
Location: Derbyshire
Posts: 542
I'm mark.