I bought this as a stop gap whilst my Cadenza Bronze was being looked over,Purchased from Hifihanger and described as very low hours.
In good condition.
£295 including postage.
Location: brighton
Posts: 128
I'm jamie.
I bought this as a stop gap whilst my Cadenza Bronze was being looked over,Purchased from Hifihanger and described as very low hours.
In good condition.
£295 including postage.
Location: brighton
Posts: 128
I'm jamie.
evening bump for a great cartridge!
Hi
What's the loading requirement for this. I'm looking at getting a vintage Rotel Pre with a MC input.
Sent from my SM-S918B using Tapatalk
Location: brighton
Posts: 128
I'm jamie.
google is your friend but i think i had it on 50 ohms
MC 30 Supreme
- Output voltage at 1000 Hz, 5cm/sec.: > 500 µV
- Channel balance at 1 kHz: < 1.0 dB
- Channel separation at 1 kHz: > 27 dB
- Frequency response: 20-40.000 Hz
- Tracking ability (315Hz, lateral): > 80 µm
- Compliance, dynamic (lateral): 16 µm/mN
- Stylus type: Super Nude Fine Line
- Stylus tip radius: r/R 8/60 µm
- Tracking force range: 1.8-2.2 g (18-22 mN)
- Tracking force, recommended: 2.0 g (20 mN)
- Tracking angle (vertical): 20°
- Internal impedance: 5 Ohm
- Recommended load impedance: > 20 Ohm
- Cartridge weight: 10.7 g
GLWS
Barry
Location: brighton
Posts: 128
I'm jamie.
thanks barry.
They were great carts, lovely tip, a precursor to the replicant.
Kuzma Stabi/S 12", (LP12-bastard) DC motor and optical tacho psu, Benz LP, Paradise (phonostage). MB-Pro, Brooklyn dac and psu, Bruno Putzeys balanced pre, mod86p dual mono amps, Yamaha NS1000m
Location: brighton
Posts: 128
I'm jamie.
indeed,to the top and open to offers.
Location: brighton
Posts: 128
I'm jamie.
bump