Fitting a Mayware pick-up arm into a Linn pattern cut out

[Rare Bird]

As above

Here's what ive done for anyone wanting to perform this operation

Since the Linn pattern mounting hole is a lot bigger than the required Mayware mount some centralisation is required.

The easiest thing to do for the underside is make an aluminium ring with the correct size mounting hole, mark The linn pattern mounting position on the ring, tap three M4 fixings. Your fixing bolts need to stick out the other side this is what aid's alighnment (You can use one of these fixing for your TT ground lead).

The top plate simply has the required Mayware mounting hole noting else

Just place the top plate over the original hole, slip in the Mayware mounting collar, place the underside ring over the collar, the pertruding bolts will fall into the linn mount fixing holes & all will be centralised, just fit the locking nut & hey presto two plates sandwiching the original board. jobs a good un





All i need to do now is polish the bottom ring to match the top even though i won't see it