They are very good IMO Martin,get your finger out!
Don McCorleone
Location: Galashiels
Posts: 13,695
I'm inthescottishmafia.
They are very good IMO Martin,get your finger out!
Senior Member
Location: Cheshire, UK
Posts: 2,829
I'm Clive.
Ahh well now.....I mustn't give away all my secrets.Originally Posted by Ali Tait
...Or you could tell me how to get some free!
TT 1 Trans-Fi Salvation with magnetic bearing + Trans-Fi Terminator T3Pro + London Reference
TT 2 Garrard 301 with NWA main bearing + Audiomods Series Six 10.5" + Ortofon 2M Mono SE
Digital Lindemann Bridge + Gustard R26 with LB external clock
Pre and Power Amp EWA M40P + M40A
Bass Amp & DSP Behringer iNuke NU3000DSP x 2
Speakers 1 Bastanis Sagarmatha Duo with twin baffleless 15" bass drivers per side
Speakers 2 MarkaudioSota Viotti Tower
Ok - doing it now!
Done it and it's running-in on MTV HD. Will give it a proper listen tomorrow.
Last edited by MartinT; 27-11-2012 at 07:10. Reason: Changed photo hosting
Don McCorleone
Location: Galashiels
Posts: 13,695
I'm inthescottishmafia.
Think you will be pleasantly surprised Martin,they do take a while to run in though.
Don McCorleone
Location: Galashiels
Posts: 13,695
I'm inthescottishmafia.
Ok,PM me then!
Member
Location: Co Durham
Posts: 50
About time you got those ESA's in Martin
Cheers Andy
''You canna break the laws of Physics Jim"
Andy.
First impressions of the ClarityCaps are good: highly transparent, extended treble, good soundstage. I'm hoping that the bass will extend out as it is a little light at the moment compared with the Rubycons.
Don McCorleone
Location: Galashiels
Posts: 13,695
I'm inthescottishmafia.
It will.May take a while though.
Member
Location: Down Under
Posts: 34
Hi guys,
From back to front of PIN3A (actually called "PIN3B" on the lower board) the connections are:
o Cap A +ve
o Cap A -ve
o no connection
o Cap B -ve
o Cap B +ve
Andrew
I am quite interested in doing this mod however i like to ask some questions before i attempt to do it.
1. Andrew's method is the only option if i were to do it without soldering right?
2. i am a bit confused on how the caps would actually slot into the PIN3A. I am assuming its not soldered but if i just shove it down to the pin would the caps make a firm enough contact to the slot (i'm just thinking about it since i would assume those cap legs are not usually meant to be used that way unlike the opamps dip8 legs)
3. Also if i do it Andrew's way i understand i would lose the headphone out but do i also lose the variable output (or does it become a 2nd fixed output)?
4. Since i am in Aus i would guess the best place is to buy the caps that are sold from Tirna right?
Cheers,
Sonny
Last edited by sum1; 27-09-2010 at 01:15. Reason: typo
Cheers,
Sonny
Posting Permissions
Reply With Quote
