Originally Posted by
andyrlb
Here goes ...
Sent from my iPhone using Tapatalk
Andy, how did you meter test this step? Across the two pips to measure resistance or each pip back to its corresponding terminal on the back for continuity?
If continuity is fine from each pip to its corresponding rear terminal then try continuity between each pip to where the corresponding lug is on the voice coil. (you may have to remove the dustcap, but I think I read elsewhere in this thread that you did remove the dustcap anyway). With a bit of luck it is only a continuity issue requiring a rebraid or renewal of the thin wire.
Current: [P20] Roon/Tidal > Custom PC> Chevron Paradox NDF16 > Phast Pre > Neuro. 686 > Tannoy Berkley (RFC tweaks)