I am approaching to the measurement of the internal volume:
From waste material I made this gadget ,that takes part in the measurements and when assembling the cabinet:/p-4,5/
I am approaching to the measurement of the internal volume:
From waste material I made this gadget ,that takes part in the measurements and when assembling the cabinet:/p-4,5/
I have to make another post, sorry!
My method of finding an internal volume of a complex construction was discovered long ago,
the answer was given so many years ago,/about 2500/ of the Archimedes genius!
The volume per liter of water is equal to the volume of 1 kg. and 1l. Water = 1 kg,
-their specific resistances are the same, with very little error.
I will say it in a more understandable way:
- if we have 20 liters of water in a bucket, this bucket will weigh approximately -20 kg.
- if we have another liquid in this bucket, we may have 20 liters, but we will not have 20 pounds.
In my method of measurement, i do not immerse the inner construction in the water, just I measure the weight and deduct it from the total volume.
There is no simpler and more accurate method for finding the volume of a complex body,
Archimed's method is flawless!
Any other material we use to fill, we need to know the "ro" of this material.
On the second picture,the red line is the waterline, the vas of cabinet must be fill with water next to it / everything must be perfectly horizontally!/.
Remarkable work - well done!
100% Analogue
Stunning work, that's a real commitment to a big project.
Kuzma Stabi/S 12", (LP12-bastard) DC motor and optical tacho psu, Benz LP, Paradise (phonostage). MB-Pro, Brooklyn dac and psu, Bruno Putzeys balanced pre, mod86p dual mono amps, Yamaha NS1000m
And I am approaching to the measurement of the internal volume:
I measure the weight of the my vented inner construction - 3.5 kg.
-The amount of water is 42 l. in the box; the average value relative to the density of MDF is 0.75 kg. of a cubic decimeter,3,5/0,75=4,7l, 42-4,7l= 37.3l more than what's needed - what's next?
The problem is that my investor likes the vision of the column.The decrease in volume must occur inside the construction of the cabinet.This sends the project in a more initial phase,we have a new requirement for the project, another W18 EX001.The old project stayed in the past ...
Last edited by jororaitchev; 20-04-2018 at 19:03.
After preprocessing of the internal ribbing I can now start collecting the cabinets;
Now I can make the exact measurement of the volume.
And that's 31.5l, just as much as I need!