Hi i just need a bit of advice , i have got a oyaid mj12 , this has a 1degree incline , would i have to set the cartridge azimuth to that to get the best from the matt and make the cartridge follow the grove as if it was on a level surface ?
Hi i just need a bit of advice , i have got a oyaid mj12 , this has a 1degree incline , would i have to set the cartridge azimuth to that to get the best from the matt and make the cartridge follow the grove as if it was on a level surface ?
I obsessed about this for years until I got the Reed 3P which has azimuth adjustment on the fly - up to about 30°. What I've realised since getting it is that it isn't quite as important as I thought for so long. It takes a lot of adjustment for a minimal change - once you have it set forget about it.
Technics SP10 mk2
Jan Allaerts MC 1 Boron mk1 cart
Miyajima Shilabe cart
Hashimoto HM-X SUT
Siggwan (gimballed not unipivot) Cocobola 12"
Aurorasound Vida LCR Phonostage
The Truth linestage
Dave Slagle Autoformer Volume Controller
Cary 805c SET amps
Audio Note ANe-SPX speakers
Townshend Isolda speaker cables
Cardas Golden Presence interconnects
Hi , i just wondered as the azimuth was out and the stero imaging was not quit right ,this was with out the mj12 using a acromatt , once i adjusted it to were it was level it was fine , but now i have a new oyaide mj12 go back on the deck i will see what difference it makes ,
michell odyssey
michell delphini dual mono
MF M6 500i
MF M6 Dac
CDT
at33 ev
oyaide sb hxw
oyaide mj12
acromatt