+ Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: Schiit Power amps: Vidar

  1. #1
    Join Date: May 2010

    Location: Worcestershire, UK

    Posts: 598
    I'm Rob.

    Default Schiit Power amps: Vidar

    It seemed an obvious missing product in their line up - so I'm not surprised to see the Schiit have released a power amp: Vidar



    I'm curious as to how it sounds.
    Rob.
    Powered by crossed fingers and clenched buttocks

  2. #2
    Join Date: Apr 2012

    Location: Southall, West London

    Posts: 35,725
    I'm Geoff.

    Default

    I'd like to know what "dual mono-ish" means.

  3. #3
    Join Date: May 2010

    Location: Worcestershire, UK

    Posts: 598
    I'm Rob.

    Default

    Quote Originally Posted by walpurgis View Post
    I'd like to know what "dual mono-ish" means.
    This is in the FAQ: " Vidar uses a dual-mono-to-the-transformer design for the main output power supply (the most important place to use it)."
    Rob.
    Powered by crossed fingers and clenched buttocks

  4. #4
    Join Date: Apr 2012

    Location: Southall, West London

    Posts: 35,725
    I'm Geoff.

    Default

    Presumably a transformer with a single core assembly but discrete windings per channel, in as well as out? I suspected that might be what they were getting at.

  5. #5
    Join Date: Jan 2009

    Location: Essex

    Posts: 17,859
    I'm openingabottleofwine.

    Default

    Most likely to be a transformer with a single primary winding (fed from the mains) with two separate secondary windings (one for each channel).

    Quad use a similar transformer in their 405 design, but curiously there the two secondary windings are wired in parallel to feed a single bridge rectifier and single power supply for both channels.
    Have you listened to this month's choice in the Album Club?

    Barry

  6. #6
    Join Date: Apr 2012

    Location: Southall, West London

    Posts: 35,725
    I'm Geoff.

    Default

    Well that makes two of my amps "dual mono-ish". Single transformer with single primary and dual secondaries feeding rectifiers for each channel.

  7. #7
    Join Date: Jan 2009

    Location: Essex

    Posts: 17,859
    I'm openingabottleofwine.

    Default

    True 'dual mono' would be two amplifiers that are completely separate and only share the mains input cable/ connector (and perhaps the on/off switch and fuse), but share the same enclosure.
    Have you listened to this month's choice in the Album Club?

    Barry

  8. #8
    Join Date: Aug 2011

    Location: Coventry, England UK

    Posts: 485
    I'm Simon.

    Default

    This looks interesting, could be a giant killer. Must say I'm tempted to try one once they land over here.

  9. #9
    Join Date: Feb 2013

    Location: Switerland

    Posts: 1,201
    I'm rupert.

    Default

    Power Consumption: 700W maximum that seems a lot. Funny that Shiit wouldn't go class-D with all the experience they have with DAC's.

  10. #10
    Join Date: May 2008

    Location: A Strangely Isolated Place in Suffolk with far away trains passing by...

    Posts: 14,447
    I'm David.

    Default

    Theta (the 'donor of design brains' for Schiit) did some damned good stuff back in the day, overshadowed here in the UK because it wasn't Krell or ARC. I do hope Schiit don't abandon their cheap goodies as they establish themselves further up-market.

    http://www.schiit.com/products/vidar

    Looks to be all transformer. the Stereophile review on the integrated shows how they might have been able to do this...

    https://www.stereophile.com/content/...r-measurements
    Tear down these walls; Cut the ties that held me
    Crying out at the top of my voice; Tell me now if you can hear me

+ Reply to Thread
Page 1 of 2 12 LastLast



 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •